VN610SP-E Datasheet, PDF (1/18 Pages) STMicroelectronics – SINGLE CHANNEL HIGH SIDE DRIVER

VN610SP-E
SINGLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
VN610SP-E
10 mΩ
I_out
45 A
V_CC
36 V
Figure 1. Package
sOUTPUT CURRENT: 45 A
s CMOS COMPATIBLE INPUT
s PROPORTIONAL LOAD CURRENT SENSE
n s UNDERVOLTAGE AND OVERVOLTAGE
SHUT-DOWN
s OVERVOLTAGE CLAMP
s THERMAL SHUT DOWN
s CURRENT LIMITATION
s VERY LOW STAND-BY POWER DISSIPATION
s PROTECTION AGAINST:
n LOSS OF GROUND AND LOSS OF V_CC
s REVERSE BATTERY PROTECTION (*)
s IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
10
1
PowerSO-10™
DESCRIPTION
The VN610SP-E is a monolithic device made
using STMicroelectronics VIPower M0-3
technology. It is intended for driving resistive or
inductive loads with one side connected to ground.
Active V_CC pin voltage clamp protects the device
against low energy spikes (see ISO7637 transient
compatibility table).
This device integrates an analog current sense
which delivers a current proportional to the load
current (according to a known ratio). Active current
limitation combined with thermal shut-down and
automatic restart protect the device against
overload. Device automatically turns off in case of
ground pin disconnection.
Table 2. Order Codes
Package
PowerSO-10™
VN610SP-E
Tube
Note: (*) See application schematic at page 9
October 2004
Tape and Reel
VN610SPTR-E
Rev. 1
1/18