VN340SP-E Datasheet, PDF (1/16 Pages) STMicroelectronics – Quad high side smart Power solid state relay

VN340SP-E
Quad high side smart
Power solid state relay
Features
Type
V_demag(1) R_DSon(1)
VN340SP-E V_CC-55V 0.2Ω
1. Per channel.
I_out(1)
0.7A
V_CC
36V
■ Output current : 0.7A per channel
■ Digital I/O‘s clamped at 32V minimum voltage
■ Shorted load and overtemperature protections
■ Protection against loss of ground
■ Built-in current limiter
■ Undervoltage shut-down
■ Open drain diagnostic output
■ Fast demagnetization of inductive loads
■ Conforms to IEC 61131-2
Figure 1. Block diagram
PowerSO-10^TM
Description
The VN340SP-E is a monolithic device made
using STMicroelectronics VIPower technology,
intended for driving four indipendent resistive or
inductive loads with one side connected to
ground. Active current limitation avoids dropping
the system power supply in case of shorted load.
Built-in thermal shut-down protects the chip from
overtemperature and short circuit. The open drain
diagnostic output indicates overtemperature
conditions. Each I/O is pulled down when
overtemperature condition of the relative channel
is verified.
March 2007
Rev 5
1/16
www.st.com
16