VN31_04 Datasheet, PDF (1/13 Pages) STMicroelectronics – ISO HIGH SIDE SMART POWER SOLID STATE RELAY

VN31
ISO HIGH SIDE SMART POWER SOLID STATE RELAY
Table 1. General Features
Type
V_DSS
R_DS(on)
I_n ⁽¹⁾
V_CC
VN31
60 V 0.03 Ω 11.5 A 26 V
Note: 1. In= Nominal current according to ISO definition for high
side automotive switch. The Nominal Current is the
current at T_c = 85 °C for battery voltage of 13V which
produces a voltage drop of 0.5 V.
Figure 1. Package
■ MAXIMUM CONTINUOUS OUTPUT
CURRENT (note 2): 31 A @ T_c= 85°C
■ 5V LOGIC LEVEL COMPATIBLE INPUT
■ THERMAL SHUT-DOWN
■ UNDER VOLTAGE PROTECTION
■ OPEN DRAIN DIAGNOSTIC OUTPUT
■ INDUCTIVE LOAD FAST DEMAGNETIZATION
■ VERY LOW STAND-BY POWER
DISSIPATION
Note: 2. The maximum continuous output current is the current at
T_c = 85 °C for a battery voltage of 13 V which does not
activate self protection.
DESCRIPTION
The VN31 is a monolithic device made using
STMicroelectronics VIPower Technology,
intended for driving resistive or inductive loads
with one side grounded.
Built-in thermal shut-down protects the chip from
over temperature and short circuit.
The open drain diagnostic output indicates: open
load in off state and in on state, output shorted to
V_CC and overtemperature. Fast demagnetization
of inductive loads is achieved by negative (-18V)
load voltage at turn-off.
PENTAWATT
(vertical)
PENTAWATT
(horizontal)
PENTAWATT
(in-line)
Table 2. Order Codes
Package
PENTAWATT Vert.
PENTAWATT Hor.
PENTAWATT In line
Tube
VN31
VN31(011Y)
VN31(012Y)
Tape and Reel
-
-
-
June 2004
REV. 2
1/13