|
VN31-E Datasheet, PDF (1/13 Pages) STMicroelectronics – ISO HIGH SIDE SMART POWER SOLID STATE RELAY | |||
|
VN31
ISO HIGH SIDE SMART POWER SOLID STATE RELAY
Table 1. General Features
Figure 1. Package
Type
VDSS
RDS(on)
In (1)
VCC
VN31
60 V 0.03 ⦠11.5 A 26 V
) Note: 1. In= Nominal current according to ISO definition for high
t(s side automotive switch. The Nominal Current is the
current at Tc = 85 °C for battery voltage of 13V which
produces a voltage drop of 0.5 V.
duc â MAXIMUM CONTINUOUS OUTPUT
ro CURRENT (note 2): 31 A @ Tc= 85°C
P â 5V LOGIC LEVEL COMPATIBLE INPUT
te â THERMAL SHUT-DOWN
le â UNDER VOLTAGE PROTECTION
so â OPEN DRAIN DIAGNOSTIC OUTPUT
b â INDUCTIVE LOAD FAST DEMAGNETIZATION
- O â VERY LOW STAND-BY POWER
) DISSIPATION
t(s Note: 2. The maximum continuous output current is the current at
Tc = 85 °C for a battery voltage of 13 V which does not
c activate self protection.
rodu DESCRIPTION
P The VN31 is a monolithic device made using
STMicroelectronics VIPower Technology,
te intended for driving resistive or inductive loads
le with one side grounded.
o Built-in thermal shut-down protects the chip from
s over temperature and short circuit.
ObThe open drain diagnostic output indicates: open
PENTAWATT
(vertical)
PENTAWATT
(horizontal)
PENTAWATT
(in-line)
load in off state and in on state, output shorted to
VCC and overtemperature. Fast demagnetization
of inductive loads is achieved by negative (-18V)
load voltage at turn-off.
Table 2. Order Codes
Package
PENTAWATT Vert.
PENTAWATT Hor.
PENTAWATT In line
Tube
VN31
VN31(011Y)
VN31(012Y)
Tape and Reel
-
-
-
June 2004
REV. 2
1/13
|
▷ |