VIPER38 Datasheet, PDF (1/31 Pages) STMicroelectronics – VIPerPlus family: peak power high-voltage converter

VIPER38
VIPerPlus family: peak power high-voltage converter
Figure 1. Typical application
н
,ŝŐŚsŽůƚĂŐĞ
ŝŶƉƵƚ
(37
'5$,1
&217
9,3HU
9''
)%
*1'
;ŽƉƚŝŽŶĂůͿ
Ͳ
н
ŽƵƚƉƵƚ
Ͳ
Features
• 800 V avalanche-rugged power MOSFET
allowing ultra wide range input V_ac to be
achieved
• Embedded HV start-up and sense FET
• PWM current-mode controller
• OCP with selectable threshold (I_Dlim) and 2^nd
OCP with higher value (I_DMAX) to protect the IC
from transformer saturation or short-circuit of
the secondary diode
• 30 mW no-load consumption at 230 V_ac
• Two operating frequencies:
– 60 kHz (L type) or 115 kHz (H type)
• Jittered frequency reduces the EMI
• Extra power timer (EPT) blanks the overload
current for few seconds
Datasheet - production data
• Output overvoltage protection with tight
tolerance and digital noise filter
• Soft-start reduces the stress during startup and
increases IC lifetime
• Automatic restart after a fault condition
• Thermal shutdown increases system reliability
and IC lifetime
Applications
• Auxiliary power supply for consumer and home
equipment
• Power supply for energy meters and data
concentrators
• Adapters
Description
The device is a high-voltage converter that
smartly integrates an 800 V rugged power
MOSFET with PWM current-mode control. The
power MOSFET allows a very high input V_ac to be
applied, just limited from its breakdown voltage.
This IC is capable of meeting more stringent
energy-saving standards as it has very low
consumption and operates in burst mode under
light load.
The device features an adjustable extra power
timer (EPT) that enables the IC to sustain
overload conditions for a few seconds.
The integrated HV startup, sense FET and
oscillator with jitter allow the advantage of using
minimal components in the application.
The device features high-level protections like
dual-level OCP, output overvoltage, short-circuit,
and thermal shutdown with hysteresis. After the
removal of a fault condition, the IC is
automatically restarted.
July 2015
This is information on a product in full production.
DocID025703 Rev 2
1/31
www.st.com