UM1599 Datasheet, PDF (1/17 Pages) STMicroelectronics – The STPM01 and STPM1x evaluation software

UM1599
User manual
The STPM01 and STPM1x evaluation software
Introduction
The STPM1x evaluation software is a graphical user interface to read, configure and
calibrate the STPM01 or STPM1x single phase energy metering device, suitable for parallel
and USB hardware interfaces.
The application has a unique work area where the user can read the device’s registers and
write configuration and calibration parameters.
It is possible to select a specific device and configure application parameters (such as
sensor sensitivity, crystal oscillator frequency) to calculate measured power, current and
voltage.
Data acquisition can be customized to read either a single or a number of data samples
from the device. Reading data can be output in table format and saved as excel file.
Wizard tools are provided to guide the user during the application design and automatically
calibrate the device.
At any time it is possible to save the current session data in a project, to open an existing
project or to create a new project.
Figure 1. STPM1x evaluation software screenshot
August 2013
DocID024146 Rev 1
1/17
www.st.com