UM1488 Datasheet, PDF (1/17 Pages) STMicroelectronics – STPMC1 evaluation software

UM1488
User manual
STPMC1 evaluation software
Introduction
STPMC1 evaluation software is a graphical user interface to read, configure and calibrate an
STPMC1 energy metering device, suitable for parallel and serial hardware interfaces.
The application has a unique work area where the user can read device registers and write
configuration and calibration parameters.
It is possible to configure application parameters (such as sensor sensitivity, crystal
oscillator frequency) to calculate measured energy, current and voltage.
Data acquisition can be customized to read either a single or a certain number of data
samples from the device. Read data can be output in table format and saved to an Excel file.
Two wizard tools are provided to guide the user during the application design and
automatically calibrate the device.
At any time it is possible to save current session data in a project, to open an existing project
or to create a new project.
Figure 1. STPMC1 evaluation software screenshot
December 2011
Doc ID 022451 Rev 2
1/17
www.st.com