UM0156 Datasheet, PDF (1/35 Pages) STMicroelectronics – SDK-ST10F269 Quick Start Software Development Kit

UM0156
USER MANUAL
SDK-ST10F269 Quick Start Software Development Kit
Introduction
This SDK-ST10F269 Quick Start Software Development Kit User Manual provides extensive information
about the development board, including board diagrams, associated schematics, main components, and
connectors. The SDK-ST10F269 Kit includes a two-layer, low-cost development board with an ST10F269
16-bit Embedded Flash Memory Microcontroller. The board features versatile circuitry which allows the
user to develop a variety of applications. The SDK-ST10F269 is considered a general purpose
application board used for developing advanced motor control solutions and processing external data
(e.g., sensor outputs).
Three dedicated connectors for motion control allow the user to control different kinds of motors by
plugging in external power motor boards. An RS232 connector, two Controller Area Network (CAN)
connectors, and one I²C connector are used for additional external device management. In particular, the
I²C bus framework is used to connect to an EEPROM IC embedded in the board (see Figure 3 on
page 7).
See associated datasheets and technical literature for details about the components related to the
ST10F269 development board (on the companion CD-ROM or on the web):
■ http://www.st.com/mcu/ (ST10F269 information and User Manual)
■ http://www.st.com/powerspin/ (L6205, L6235 information)
■ http://www.st.com/ (L6386 information)
Figure 1. SDK-ST10F269 Development Board
September 2013
Rev 2
1/35
http:/www.st.com
35