STLVDS104_06 Datasheet, PDF (1/12 Pages) STMicroelectronics – 4-port lvds and 4-port TTL-to LVDS repeaters

STLVDS104
4-port lvds and 4-port TTL-to LVDS repeaters
Feature summary
I Receiver and drivers meet or exceed the
requirements of ansi eia/tia-644 standard,
receivers differential input levels, ±100mV
I Designed for signaling rates up to 630mbps
I Operates from a single 3.3V supply
I Low voltage differential signaling with typical
output voltage of 350mV and a 100Ω load
I Propagation delay time: 3.1ns (typ)
I Electrically compatible with LVDS, PECL,
LVPECL, LVTTL, LVCOMOS, GTL, BTL, CTT,
SSTL, or HSTL outputs with external network
I Bus terminal ESD (HBM) exceeds 7kV
I TSSOP package
Description
The STLVDS104 is a differential line receiver and
a LVTTL input connected to four differential line
drivers that implement the electrical
characteristics of low voltage differential
signaling, for point to point baseband data
transmission over controlled impedance media of
approximately 100Ω. The transmission media can
be printed-circuit board traces, backplanes, or
cable.
LVDS, as specified in EIA/TIA-644 is a data
signaling technique that offers low-power, low
TSSOP
noise coupling, and switching speed to transmit
data at a speed up to 630Mbps at relatively long
distances.
The drivers integrated into the same substrate,
along with the low pulse skew of balanced
signaling, allow extremely precise timing
alignment of the signals repeated from the input.
The device allows extremely precise timing
alignment of the signal repeated from the input.
This is particularly advantageous in distribution or
expansion of signals such as clock or serial data
stream.
.
Order codes
Type
STLVDS104BTR
March 2006
Temperature
Range
-40 to 85 °C
Package
TSSOP16 (Tape & Reel)
Rev. 5
Comments
2500 parts per reel
1/12
www.st.com
12