STLVDS051 Datasheet, PDF (1/11 Pages) STMicroelectronics – HIGH SPEED DIFFERENTIAL LINE DRIVERS AND RECEIVERS

STLVDS051
HIGH SPEED DIFFERENTIAL LINE
DRIVERS AND RECEIVERS
s MEETS OR EXCEED THE REQUIREMENTS
OF ANSI EIA/TIA-644-1995 STANDARD
s SIGNALING RATES UP TO 400Mbit/s
s BUS TERMINAL ESD EXCEEDS 6KV
s OPERATES FROM A SINGLE 3.3V SUPPLY
s LOW-VOLTAGE DIFFERENTIAL SIGNALING
WITH TYPICAL OUTPUT VOLTAGE OF
350mV AND A 100Ω LOAD
s PROPAGATION DELAY TIMES:
DRIVER: 2ns (TYP)
RECEIVER: 3ns (TYP)
s POWER DISSIPATION AT 200MHz:
DRIVER: 25mW (TYP)
RECEIVER: 60mW (TYP)
s LVTTL INPUT LEVELS ARE 5V TOLERANT
s RECEIVER HAS OPEN-CIRUIT FAIL-SAFE
DESCRIPTION
The STLVDS051 is differential line drivers and
receivers that use low-voltage differential
signaling (LVDS) to achieve signaling rate as high
as 400Mbps.
The EIA/TIA-644 standard compliant electrical
interface provides a minimum differential output
voltage magnitude of 247 mV into a 100 Ω load
and receipt of 100 mV signals with up to 1 V of
SOP
TSSOP
ground potential difference between a transmitter
and receiver.
The intended application of this device an
signaling technique is for point-to-point baseband
data transmission over controlled impedance
media of approximately 100 Ω characteristic
impedance.
The transmission media may be printed-circuit
board traces, backplanes, or cables. (Note: The
ultimate rate and distance of data transfer is
dependent upon the attenuation characteristics of
the media, the noise coupling to the environment,
and other application specific characteristics).
ORDERING CODES
Type
STLVDS051BD
STLVDS051BDR
STLVDS051BTR
Temperature
Range
-40 to 85 °C
-40 to 85 °C
-40 to 85 °C
Package
SO-16 (Tube)
SO-16 (Tape & Reel)
TSSOP16 (Tape & Reel)
Comments
50 parts per tube / 20 tube per box
2500 parts per reel
2500 parts per reel
July 2003
1/11