STEVAL-ISS001V1 Datasheet, PDF (1/4 Pages) STMicroelectronics – Line interactive 450 W UPS reference design - 120 V / 60 Hz model

STEVAL-ISS001V1
Features
Line interactive 450 W
UPS reference design - 120 V / 60 Hz model
Data Brief
■ Output rating power: 700 VA / 450 W
■ Input voltage: 83 Vac ± 3% - 153 Vac ± 3%
■ Input frequency: 60 Hz
■ Output voltage: 96 - 138 Vac ± 3 Vac
■ Output frequency: 60 Hz ± 0.1 Hz
■ On battery output waveform: quasi-sine
(square wave)
■ Transfer time: Class 3 [EN62040-3]
■ Typical recharge time: 8h
■ Backup time (full load): 2.5 - 3 min.
■ Battery quantity: 2 pieces
■ Battery nominal voltage: 12 V
■ Battery capacity: 7.2 Ah
■ Battery recharge: two steps
■ Operating temperature: 0 °C to + 40 °C
■ Storage temperature: - 20 °C to + 60 °C
■ Size (H x W x D): 175 mm x 120 mm x 430 mm
■ Weight: 11 kg
■ Shipping weight: 11.5 kg
■ EMI classification: EN 62040-2
STEVAL-ISS001V1
The UPS was designed with RS-232 joint signal
and USB interfaces (USB for RS-232 converter). It
is possible to connect the UPS to a PC using an
RS-232 or USB cable and control the UPS status
through the "UPS Monitor 3.0x" software that
must be installed on the same PC.
Description
This UPS reference design was built employing
off-line topology with AVR boost and buck
regulation of the mains. The inverter module
contains the push-pull DC-DC converter and the
DC-AC output full bridge generating a quasi-sine
waveform.
A microcontroller controls all UPS functions. It
monitors the mains parameters (input/output
mains voltage and phase, output inverter voltage,
battery voltage, output current and output power)
in order to ensure the proper level of the output
voltage.
April 2008
Rev 1
For further information contact your local STMicroelectronics sales office.
1/4
www.st.com
4