STEVAL-IPT005V1 Datasheet, PDF (1/4 Pages) STMicroelectronics – Smartcard connector for testing with a smartcard

STEVAL-IPT005V1
Smart card interface evaluation board based on the ST8034P
Features
• Smartcard connector for testing with a
smartcard
• Labeled testpoints provide accessibility to all
the signals
• Board design allows standalone operation for
basic tests
• Interface to an MCU block and simple board
configurability allow even full functioning in
applications (i.e. set-top box)
• Onboard 10 MHz crystal clock oscillator can be
used to provide card clock in standalone
operation
• Card clock source selection switch allows
selection between the onboard crystal
oscillator as card clock source, or an external
clock source provided by the microcontroller
block through the MCU interface together with
the data signals
• Provides easy, flexible card supply voltage
selection either by onboard configuration
switches or remotely by the microcontroller
• RoHS compliant
Data brief
Description
The STEVAL-IPT005V1 product evaluation board
is designed both for standalone operation or to be
controlled by the microcontroller. The board is
fully configurable, provides access to all signals
including supply voltage through labeled test
points, and uses a standard connector for simple
communication interfacing with the
microcontroller block. The labeled test points on
the board are in the same order as the signals in
the flat interface cable.
The board provides easy and flexible card supply
voltage (V_CC) selection, either through the
onboard configuration switch (driving the tri-state
V_CC selection input pin VCC_SEL) or through the
microcontroller.
The STEVAL-IPT005V1 product evaluation board
addresses market segments including: POS, set-
top boxes, pay TV, identification, banking and
tachographs.
April 2014
DocID025478 Rev 2
For further information contact your local STMicroelectronics sales office.
1/4
www.st.com