STEVAL-ILL043V1 Datasheet, PDF (1/5 Pages) STMicroelectronics – RoHS compliant

STEVAL-ILL043V1
High end, 75 W high power factor flyback LED driver based on the
L6562A with two dimmable strings
Data brief
Features
■ Mains voltage range V_ACmin = 165V_ac,
V_ACmax = 277 V_ac
■ Minimum mains frequency f_l = 47 Hz
■ DC output voltage V_out = 65 V
■ Maximum output current I_out = 1.5 A
■ Maximum 2fL output ripple ΔVO% = 1.0%
■ Minimum switching frequency f_swmin = 40 KHz
■ Expected efficiency: 90%
■ RoHS compliant
STEVAL-ILL043V1
Description
The STEVAL-ILL043V1 demonstration board is a
high-PF flyback configuration in order to drive a
new design of the 75 W LED array based on the
L6562A controller, with a much reduced BOM
cost.
This configuration uses an isolated feedback with
an optocoupler and a secondary side
reference/error amplifier. The inverse buck
converter based on the L6562A is used for
constant voltage and constant current control in
double dimmable channels.
The L6562A is a PFC controller operating in
Transition mode. The highly linear multiplier
includes a special circuit, able to reduce AC input
current distortion, that allows wide-range-mains
operation with an extremely low THD, even over a
large load range.
The inverse buck converter shows good
performance in terms of power switch control and
conditioning circuitry signal for the current
sensing. In fact, this topology of converter allows
easy driving of the switch referred to ground by
using an L6562A driver.
An integrated auxiliary power supply provides an
energy saving action and a remote control
monitoring function for the system.
This ballast designed by using the L6562A and
the buck inverse converter offers more
advantages in terms of output current and voltage
stability.
The key benefit is the very high efficiency that, at
full load, is almost 90%.
July 2012
Doc ID 023218 Rev 1
For further information contact your local STMicroelectronics sales office.
1/5
www.st.com
5