STEVAL-IFP016V2 Datasheet, PDF (1/4 Pages) STMicroelectronics – Additional IEC61131-2 type-1 input

STEVAL-IFP016V2
IO-Link communication master transceiver demonstration board
based on the L6360, monolithic IO-Link master port
Data brief
Features
■ Supply voltage from 18 V to 32.5 V
■ Fully protected programmable output stages
■ Supports COM1, COM2 and COM3 mode
■ 5 mA IO-Link digital input
■ Additional IEC61131-2 type-1 input
■ 3.3 V / 5 V, 50 mA linear regulator
■ Fast mode I²C for IC control, configuration and
diagnostic
■ Diagnostic dual LED sequence generator and
driver
■ 5 V and 3.3 V compatible I/Os
■ Interface compatible with STEVAL-PCC009V2
and STEVAL-PCC009V1
■ EMC immune application against ESD, burst,
surge, RF noise, etc., according to IEC61000-
4-2, IEC61000-4-4, IEC61000-4-5, and
IEC61000-4-6 standards
■ RoHS compliant
Description
The STEVAL-IFP016V2 IO-Link communication
master transceiver demonstration board is based
on the L6360, monolithic IO-Link master port. A
modular and customizable application that
interfaces externally with the microcontroller. The
purpose of the board is to demonstrate the
capability of the L6360 monolithic IO-Link master,
as communication transceiver for multiple I/Os.
The board uses input signal from the
microcontroller and outputs the 24 V required for
industrial applications.
The board demonstrates that the L6360 is both
IO-Link master port mode and standard IO mode
compliant.
The interface is compatible with the STEVAL-
PCC009V2 and STEVAL-PCC009V1 EMC-
immune application against ESD, burst, surge, RF
noise, etc., according to IEC61000-4-2,
IEC61000-4-4, IEC61000-4-5, and IEC61000-4-6
standards.
A large GND area on the printed circuit board has
been designed in order to minimize noise and
ensure good thermal performance.
The small size of the L6360 package with a
reduced pin number, along with the small size of
the application area, allow the user to work in
applications where space constraint is critical.
The L6360 is a monolithic IO-Link master port,
compliant with PHY2 (3 wires) supporting COM1
(4.8 kbaud), COM2 (38.4 kbaud) and COM3
(230.4 kbaud) modes. The output stage (high-
side, low-side or push-pull) as well as the cutoff
current, cutoff current delay time, and restart
delay, are programmable by I²C protocol.
The cutoff current and cutoff current delay time,
combined with the thermal shutdown and
automatic restart, protect the device against
overload and short-circuit. The output stages are
able to drive resistive, inductive and capacitive
loads. Fast demagnetization is able to dissipate
the energy stored in the inductive loads.
September 2012
Doc ID 023081 Rev 2
For further information contact your local STMicroelectronics sales office.
1/4
www.st.com
4