STEVAL-CBL011V1 Datasheet, PDF (1/4 Pages) STMicroelectronics – Selectable output current limit by external resistor

STEVAL-CBL011V1
DiSEqC 1.X-compliant dual LNB supply and control IC based on
the LNBH26
Data brief
Features
■ Complete interface between LNB and I²C bus
■ Built-in DC-DC converter for single 12 V supply
operation and high efficiency (typ. 93% @
0.5 A)
■ Selectable output current limit by external
resistor
■ Compliant with main satellite receiver output
voltage specification (15 programmable levels)
■ Accurate built-in 22 kHz tone generator
compliant with widely accepted standards
■ 22 kHz tone waveform integrity guaranteed
also in no load condition
■ Low drop post regulator and high efficiency
step-up PWM with integrated power N-MOS for
low power loss
■ LPM (low power mode) function to reduce
dissipation
■ Overload and overtemperature internal
protection with I²C diagnostic bits
■ LNB short-circuit dynamic protection
■ RoHS compliant
The LNBH26 demonstration board includes an
I²C bus interface and a factory-trimmed internal
22 kHz tone generator which can be controlled
through the DSQIN pin (TTL compatible). This
allows immediate DiSEqC™ data encoding.
Thanks to a fully integrated step-up DC-DC
converter, the STEVAL-CBL011V1 demonstration
board can operate with a single input voltage
supply source, ranging from 8 to 15 V.
Description
The STEVAL-CBL011V1 demonstration board
implements a DC-DC converter based on ST’s
LNBH26 device. It is used to power LNBs in dish
antennas to receive satellite TV signals.
The LNBH26 is an integrated solution for
supplying/interfacing satellite LNB modules in
accordance with international standards.
This single device offers a complete solution for
dual-tuner satellite receivers and provides good
performance at low cost using a low external
component count.
February 2013
Doc ID 024061 Rev 1
For further information contact your local STMicroelectronics sales office.
1/4
www.st.com
4