STEVAL-CBL010V1 Datasheet, PDF (1/4 Pages) STMicroelectronics – Selectable output current limit using an external resistor

STEVAL-CBL010V1
Single LNB supply and control IC DiSEqC 2.0 compliant based
on the LNBH25
Data brief
Features
• Complete interface between LNB and I²C
bus
• Built-in DC-DC converter for single 12 V
supply operation and high efficiency (typ.
93% at 0.5 A)
• Selectable output current limit using an
external resistor
• Compliant with main satellite receiver output
voltage specifications (15 programmable
levels)
• Accurate built-in 22 kHz tone generator suits
widely accepted standards
• 22 kHz tone waveform integrity guaranteed
also at no load
• Low-drop post-regulator and high-efficiency
step-up PWM with integrated power N-MOS
allowing low power losses
• LMP function (low-power mode) to reduce
dissipation
• Overload and overtemperature internal
protection with I²C diagnostic bits
• LNB short-circuit dynamic protection
• RoHS compliant
Description
This product evaluation board implements a DC-
DC converter based on the LNBH25 device used
to power LNBs inside dish antennas which
receive satellite TV signals. The LNBH25 is an
integrated solution for supplying/interfacing
satellite LNB modules in accordance with
international standards, offering a complete
solution for single tuner satellite receivers and
good performance at low cost using few external
components. The LNBH25 evaluation board
includes an I²C bus interface and the internal
22 kHz tone generator (factory trimmed) is
controlled by the DSQIN pin (TTL compatible),
permitting immediate DiSEqC™ data encoding. A
fully integrated step-up DC-DC converter allows
operation with a single input voltage supply
source ranging from 8 V to 16 V.
April 2014
DocID025830 Rev 1
For further information contact your local STMicroelectronics sales
office
1/4
www.st.com