ST7MC-KIT Datasheet, PDF (1/5 Pages) STMicroelectronics – Auxiliary power supply and voltage rectification

ST7MC-KIT/BLDC
Softec’s complete motor control starter kit for ST7MC
Data brief
Features
■ Motor control board
– Motor and board input power stage
– Optoisolation board
– Auxiliary power supply and voltage
rectification
– Push buttons, trimmers for standalone
operation
– Hall sensor input
– Three-phase outputs to motor
– Tachometer input for closed-loop controlled
AC motors
– 10-pin ICC connector for in-circuit
programming and in-circuit debugging
– Prototyping area
– RS-232 connector
■ Control panel software
– Parameter configuration for BLDC and 3-
phase induction motors
– Basic settings interface for configuring
motor, start-up and real time parameters
– Advanced settings interface for configuring
frequency, speed range, stop conditions,
etc.
– Outputs header files for your application
taking into account modifications to the
configuration
■ STXF-INDART/USB
– 10-pin ICC connection
– USB connection to host PC
– Two breakpoints
– Advanced breakpoints on data, access
type, access range, stack.
Description
The Softec motor control starter kit for ST7MC
(ST ordering code: ST7MC-KIT/BLDC) is an
integrated system designed to provide you with a
complete, ready-to-use motor control application
for the ST7MC family of microcontrollers. It allows
real-time control of three-phase brushless DC and
AC motors in all control topologies from a PC-
based GUI, or in standalone operation.
The control panel software provides an easy-to-
use interface to configure, start and run the motor,
modify parameters and evaluate ST7FMC motor
control features, then generate header files for
your own motor control application.
The kit also comes with the STXF-INDART/USB
in-circuit debugger/programmer and STVD7
integrated development environment that allow
you to take advantage of the ST7FMC’s on-chip
resources for in-circuit programming and in-circuit
debugging.
For further information about the motor control
starter kit, please refer to www.st.com/mcu, or the
Softec internet site www.softecmicro.com.
For more information about inDART in-circuit
debuggers/programmers, please refer to the
ST7xxxx-INDART Data Brief.
Figure 1. Motor control starter kit for ST7
November 2011
Doc ID 11587 Rev 2
For further information contact your local STMicroelectronics sales office.
1/5
www.st.com
5