ST62T08C Datasheet, PDF (1/70 Pages) STMicroelectronics – 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, OSCILLATOR SAFEGUARD, SAFE RESET AND 20 PINS

ST62T08C/T09C
ST62T10C/T20C/E20C
8-BIT OTP/EPROM MCUs WITH A/D CONVERTER,
OSCILLATOR SAFEGUARD, SAFE RESET AND 20 PINS
s 3.0 to 6.0V Supply Operating Range
s 8 MHz Maximum Clock Frequency
s -40 to +125°C Operating Temperature Range
s Run, Wait and Stop Modes
s 5 Interrupt Vectors
s Look-up Table capability in Program Memory
s Data Storage in Program Memory:
User selectable size
s Data RAM: 64bytes
s User Programmable Options
s 12 I/O pins, fully programmable as:
– Input with pull-up resistor
– Input without pull-up resistor
– Input with interrupt generation
– Open-drain or push-pull output
– Analog Input (except ST62T08C)
s 4 I/O lines can sink up to 20mA to drive LEDs or
TRIACs directly
s 8-bit Timer/Counter with 7-bit programmable
prescaler
s Digital Watchdog
s Oscillator Safe Guard
s Low Voltage Detector for Safe Reset
s 8-bit A/D Converter with up to 8 analog inputs
s On-chip Clock oscillator can be driven by Quartz
Crystal Ceramic resonator or RC network
s Power-on Reset
s One external Non-Maskable Interrupt
s ST626x-EMU2 Emulation and Development
System (connects to an MS-DOS PC via a
parallel port)
DEVICE SUMMARY
DEVICE
ST62T08C
ST62T09C
ST62T10C
ST62T20C
ST62E20C
OTP
(Bytes)
1036
1036
1836
3884
-
EPROM
(Bytes)
-
-
-
-
3884
I/O Pins
12
12
12
12
12
Analog
inputs
-
4
8
8
8
September 1998
PDIP20
PSO20
CDIP20W
(See end of Datasheet for Ordering Information)
Rev. 2.6
1/70
89