|
ST485ER_06 Datasheet, PDF (1/19 Pages) STMicroelectronics – ±15KV ESD protected, Low power RS-485/RS-422 transceiver | |||
|
ST485ER
±15KV ESD protected, Low power
RS-485/RS-422 transceiver
General features
â Low quiescent current: 300µA
â Designed for RS-485 interface application
â -7V to 12V common mode input voltage range
â Driver maintains high impedance in 3-state or
with the power OFF
â 70mV tipycal input hysteresis
â 30ns propagation delay, 5ns skew
â Operate from a single 5V supply
â Current limiting and thermal shutdown for
driver overload protection
â ESD protection:
â ±15KV (H.B.M.)
â ±8KV (IEC-1000-4-2 contact discharge)
â Allows up to 256 transceivers on the bus
Description
The ST485E is al low power transceiver for RS-
485 and RS-422 communication. Each driver
output and receiver input is protected against
±15KV electrostatic discharge (H.B.M.) ±8KV
(IEC-1000-4-2 contact discharge) shocks, without
DIP-8
SO-8
latchup. These parts contain one driver and one
receiver.
This transceiver draws 300µA (typ.) of supply
current when unloaded or fully loaded with
disabled drivers.
It operates from a single 5V supply.
Driver is short-circuit current limited and is
protected against excessive power dissipation by
thermal shutdown circuitry that places the driver
outputs into a high-impedance state.
The ST485E is designed for bi-directional data
communications on multipoint bus transmission
line (half-duplex applciations).
Order code
Part number Temperature range
ST485ERBN
ST485ERBDR
-40 to 85 °C
-40 to 85 °C
October 2006
Package
DIP-8
SO-8 (Tape & reel)
Rev 5
Packaging
50parts per tube / 40tube per box
2500 parts per reel
1/19
www.st.com
19
|
▷ |