ST-LINK Datasheet, PDF (1/3 Pages) STMicroelectronics – In-circuit debugger/programmer for STM8 and STM32

ST-LINK
In-circuit debugger/programmer for STM8 and STM32
Data brief
Features
■ 5 V power supplied by USB connector
■ USB 2.0 full speed interface compatible
■ USB standard A to Mini-B cable provided
■ SWIM specific features:
– 1.65 V to 5.5 V application voltage
supported on SWIM interface
– SWIM low speed and high speed modes
supported
– SWIM programming speed rates of
9.7 Kbytes/s in low speed, 12.8 Kbytes/s in
high speed
– SWIM cable for connection to an
application with an ERNI standard
connector vertical (ref: 284697 or 214017)
or horizontal (ref: 214012)
– SWIM cable for connection to an
application with pin headers or 2.54 mm
pitch connector
■ JTAG/SWD specific features:
– 3 V to 3.6 V application voltage supported
on JTAG/SWD interface and 5 V tolerant
inputs
– JTAG/SWD cable provided for connection
to a standard JTAG 20-pin pitch 2.54 mm
connector
■ Direct firmware update feature supported
■ Status LED which blinks during communication
with PC
■ Operating temperature 0 to 50 °C
Table 1. Device summary
Order code
Reference
ST-LINK
ST-LINK in-circuit debugger
and programmer for the STM8
and STM32
Description
The ST-LINK is an in-circuit debugger and
programmer for the STM8 and STM32
microcontroller families. The SWIM and
JTAG/SWD interface is used to communicate with
the STM8 or STM32 microcontroller located on
your own application board.
STM8 applications use the USB full speed
interface to communicate with
STMicroelectronics’ ST Visual Develop (STVD) or
ST Visual Program (STVP) software.
STM32 applications use the USB full speed
interface to communicate with ATOLLIC®, IAR™,
KEIL™ or TASKING™ integrated development
environments.
January 2012
Doc ID 17823 Rev 2
For further information contact your local STMicroelectronics sales office.
1/3
www.st.com
3