SPC574KADPT144S Datasheet, PDF (1/4 Pages) STMicroelectronics – Master power switch and regulator status LEDs

SPC574KADPT144S
SPC574KADPT144S microcontroller premium evaluation board
for SPC574Kx
Data brief
Features
 Modular evaluation system for SPC574Kx
 Single 12 V external power supply
 Four on-board regulators:
 5.0 V, 3.3 V and 1.25 V switching
regulators
 5 V linear regulator for the ADC
supplies and references
 Master power switch and regulator status
LEDs
 Two 240-way high-density expansion
connectors for MCU daughter cards
 All MCU signals readily accessible at a port-
ordered group of 0.1” pitch headers
 RS232/SCI physical interface and standard
DB9 female connector
 Two FlexRAY channels interface with a DB9
connector (for both transceivers) and two
alternative connectors
 LINFlexD interface with two different style
connectors
 Two high speed CAN channels and two
female standard DB9 connectors
 One potentiometer for analog voltage input
and four user switches and 4 user LEDs,
freely connectable
 Open top MCU socket
 Flexible MCU clocking options
 40 MHz crystal EVB clock circuit
 8 MHz EVB clock oscillator circuit
 external clock via SMA connector
 User reset switch with reset status LEDs
 Debug ports interface:
 14-pin standard JTAG connector
 34-pin connector for Nexus 2 interface
 10-pin SIPI connector for Serial
Interprocessor Interface
 Minimodule dimension: 127 mm X 114 mm
Description
The Premium Evaluation Boards System
supports the 32-bit SPC574Kx
STMicroelectronics' automotive microcontrollers.
The complete system consists of a SPC57XXMB
motherboard and a SPC574KADPTx daughter
card which plugs into the motherboard. Different
daughter cards are available for evaluating the
whole family of device in all supported packages.
All daughter cards are similar in design and
concept.
The evaluation system (motherboard and
daughter card) allows full access to the CPU, all
of the CPU's I/O signals, and the motherboard
peripherals (such as CAN, SCI and LIN). The
daughter card itself can be used as a standalone
unit when access to the I/O pins or peripherals is
not needed.
July 2015
DocID028023 Rev 1
For further information contact your local STMicroelectronics sales
office
1/4
www.st.com