SPC56ELADPT144S Datasheet, PDF (1/4 Pages) STMicroelectronics – SPC56ELxx microcontroller family evaluation board

SPC56ELADPT144S
SPC56ELxx microcontroller family evaluation board
Features
■ SPC56xx modular evaluation system
■ On/off power switch with LED indicators
■ Board power supply: 12 VDC external supply
voltage
■ Onboard STMicroelectronics^® L9758 voltage
regulator with three simultaneous output at
1.2 V, 3.3 V and 5 V
■ Possibility to configure onboard peripherals to
operate at 5 V or 3.3 V logic levels, depending
on target
■ Two CAN channels with jumper enable
– One CAN channel with High-Speed
transceiver and DB9 male connector
– One CAN channel with Low-Speed Fault
Tolerant and High-Speed transceiver
(selectable with jumpers) and DB9 male
connector
■ Two LIN channels with jumper enable
– One channel with transceiver and pin
header connector populated
– One channel with footprints only
■ One SCI channel with jumper enables,
transceiver and DB9 female connector
■ Two FlexRay channels with jumper enables
– One channel with transceiver and DB9
male connector
– One channel with footprint only
■ Four user push buttons with jumper enable and
polarity selection
■ Four user LED’s with jumper enables
■ One potentiometer for analog voltage input
■ Pin array for accessing all I/O signals
■ Expansion connectors for accessing all I/O
signals
■ Prototyping area with 0.1” spacing and SOIC
footprint
Data brief − production data
■ Specifications:
– Board size 110 mm x 75 mm
– 12 VDC Center Positive power supply with
2.5/5.5 mm barrel connector
Description
The SPC56ELADPT144S is an evaluation system
supporting the STMicroelectronics^® SPC56ELxx
family of automotive microprocessors. The
complete system consists of a SPC56XXMB
motherboard and a mini module which plugs
directly into the motherboard. Different mini
modules are available for evaluating the whole
family of devices in all supported packages.
The evaluation system allows full access to the
CPU, to all of the CPU’s I/O signals and to the
motherboard’s peripherals (such as CAN, SCI
and LIN).
The mini module itself can be used as a stand-
alone unit when access to the I/O pins or
peripherals is not needed.
September 2012
Doc ID 023653 Rev 1
This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
1/4
www.st.com
1