|
P-NUCLEO-USB001 Datasheet, PDF (1/7 Pages) STMicroelectronics – A power connector to interface with external power supply | |||
|
P-NUCLEO-USB001
STM32 Nucleo pack for USB Type-Câ¢
and Power Delivery
Data brief
Features
⢠Two DRP USB Type-C⢠receptacles
⢠USB 2.0 FS data communication interface as
peripheral
⢠VBUS load and discharge switches
⢠VCONN switches
⢠Voltage and current sensing for VBUS
monitoring
⢠EMI filters
⢠A power connector to interface with external
power supply (not supplied)
Description
The STM32 Nucleo pack for USB Type-C⢠and
Power Delivery (P-NUCLEO-USB001) is a
development tool for learning and developing
solutions based on USB Type-C⢠and USB
Power Delivery technologies.
This tool, in association with the certified
embedded software solution (X-CUBE-USB-PD),
provides the means to control two USB Type-Câ¢
ports using a single STM32F072 32-bit
microcontroller, based on ARM® Cortex®-M0.
The X-CUBE-USB-PD is compliant with the USB
Type-C 1.2 and USB Power Delivery 2.0
specifications.
A simple analog front-end PHY is used to
interface the STM32F072 MCU with the
Configuration Channels (CC lines) of the Type-C
receptacles and to allow the communication over
these lines using the Power Delivery
communication protocol.
The P-NUCLEO-USB001 is fully configurable and
ready to support different configurations such as
Provider, Consumer or DRP.
X-CUBE-USB-PD is compliant with the USB
Type-C⢠1.2 and the Power Delivery 2.0
specifications.
1. Picture is not contractual.
February 2017
DocID029202 Rev 2
For further information contact your local STMicroelectronics sales office.
1/7
www.st.com
|
▷ |