LM-358D Datasheet, PDF (1/21 Pages) STMicroelectronics – Low-power dual operational amplifiers

LM158, LM258, LM358
Low-power dual operational amplifiers
Features
■ Internally frequency-compensated
■ Large DC voltage gain: 100 dB
■ Wide bandwidth (unity gain): 1.1 MHz
(temperature compensated)
■ Very low supply current per operator
essentially independent of supply voltage
■ Low input bias current: 20 nA
(temperature compensated)
■ Low input offset voltage: 2 mV
■ Low input offset current: 2 nA
■ Input common-mode voltage range includes
negative rails
■ Differential input voltage range equal to the
power supply voltage
■ Large output voltage swing 0 V to (V_CC+ -1.5 V)
Description
These circuits consist of two independent, high-
gain, internally frequency-compensated op-amps,
specifically designed to operate from a single
power supply over a wide range of voltages. The
low-power supply drain is independent of the
magnitude of the power supply voltage.
Application areas include transducer amplifiers,
DC gain blocks and all the conventional op-amp
circuits, which can now be more easily
implemented in single power supply systems. For
example, these circuits can be directly supplied
with the standard +5 V, which is used in logic
systems and will easily provide the required
interface electronics with no additional power
supply.
In linear mode, the input common-mode voltage
range includes ground and the output voltage can
also swing to ground, even though operated from
only a single power supply voltage.
Datasheet − production data
DIP8
(Plastic package)
SO-8 & MiniSO-8
(Plastic micropackage)
DFN8 2 x 2 mm
(Plastic micropackage)
TSSOP8
(Thin shrink small outline package)
Pin connections
(Top view)
Out1 1
In1- 2
In1+ 3
Vcc- 4
8 Vcc+
7 Out2
6 In2-
5 In2+
April 2012
This is information on a product in full production.
Doc ID 2163 Rev 10
1/21
www.st.com
21