L99MC6GJ Datasheet, PDF (1/55 Pages) STMicroelectronics – Automotive configurable 6-channel device

L99MC6GJ
Automotive configurable 6-channel device
Datasheet - production data
 Internal clamp diodes
 HS switches operate down to 3 V crank voltage
PowerSSO-16
Applications
 Relay driver
 LED driver
 Motor driver
 Mirror adjustment
Features
Description
 AEC-Q100 qualified
The L99MC6GJ IC is a highly flexible monolithic
 3 independently self configuring
high-/low-side channels
 3 low-side channels
 R_ON = 0.7  (typ) at T_j = 25 °C
medium current output driver that incorporates 3
dedicated low-side outputs (channels 4 to 6) and
3 independently self configuring outputs
(channels 1 to 3) that can be used as either low-
side or high-side drivers in any combination. The
 Current limit of each output at min. 0.6 A
 PWM direct mode
L99MC6GJ can control inductive loads,
incandescent bulbs or LEDs.
 Bulb mode with recovery mode
 LED mode with slew rate control
 Bridge mode with crosscurrent protection
 SPI interface for data communication
The L99MC6GJ can be used in a half bridge
configuration with crosscurrent protection.
The channel 2 can be controlled directly via the
IN/PWM pin for PWM applications. The IN/PWM
signal can be applied to any other output.
 Temperature warning
 All outputs overtemperature protected
The integrated 16-bit standard serial peripheral
interface (SPI) controls all outputs and provides
 All outputs short-circuit protected
 Configurable open-load detection in off mode
 V_CC supply voltage 3.0 V to 5.25 V
diagnostic information: normal operation, open-
load in off-state, overcurrent, temperature
warning, overtemperature.
 Very low current consumption in standby mode
5 µA (typ)
Table 1. Device summary
Package
Tube
Order codes
Tape and reel
PowerSSO-16
L99MC6GJ
L99MC6GJTR
November 2016
This is information on a product in full production.
DocID026835 Rev 3
1/55
www.st.com