EV-VND7140AJ Datasheet, PDF (1/7 Pages) STMicroelectronics – General device features

EV-VND7140AJ
VND7140AJ evaluation board
Data brief
Features
Max transient supply voltage
Operating voltage range
Typ. on-state resistance (per Ch)
Current limitation (typ)
Stand-by current (max)
VCC
VCC
RON
ILIMH
ISTBY
40 V
4 to 28 V
140 mΩ
12 A
0.5 µA
 Simple single IC application board dedicated
for VND7140AJ
 Provides electrical connectivity and thermal
heat-sinking for easy prototyping
 General device features
 Double channel smart high-side driver
with MultiSense analog feedback
 Very low standby current
 Compatible with 3 V and 5 V CMOS
outputs
 Diagnostic functions
 Multiplexed analog feedback of: load
current with high precision proportional
current mirror, V_CC supply voltage and
T_CHIP device temperature
 Overload and short to ground (power
limitation) indication
 Thermal shutdown indication
 OFF-state open-load detection
 Output short to V_CC detection
 Sense enable/disable
 Protections
 Undervoltage shutdown
 Overvoltage clamp
 Load current limitation
 Self limiting of fast thermal transients
 Configurable latch-off on
overtemperature or power limitation
with dedicated fault reset pin
 Loss of ground and loss of V_CC
 Reverse battery with external
components
 Electrostatic discharge protection
Applications
Typical applications are all types of automotive
resistive, inductive and capacitive loads.
Table 1: Device summary
Order code
Reference
EV-VND7140AJ VND7140AS evaluation board
September 2015
DocID026240 Rev 2
1/7
www.st.com