EV-VND7020AJ Datasheet, PDF (1/7 Pages) STMicroelectronics – Overvoltage clamp

EV-VND7020AJ
VND7020AJ evaluation board
Features
Max transient supply voltage
Operating voltage range
Typ on-state resistance (per Ch)
Current limitation (typ)
Standby current (max)
V_CC
V_CC
R_ON
I_LIMH
I_STBY
40 V
4 to 28 V
22 mΩ
63 A
0.5 µA
• Simple single IC application board dedicated
for VND7020AJ
• Provides electrical connectivity and thermal
heat-sinking for easy prototyping
• General device features
– Double channel smart high-side driver with
MultiSense analog feedback
– Very low standby current
– Compatible with 3 V and 5 V CMOS
outputs
• Diagnostic functions
– Multiplexed analog feedback of: load
current with high precision proportional
current mirror, V_CC supply voltage and
T_CHIP device temperature
– Overload and short to ground (power
limitation) indication
– Thermal shutdown indication
Data brief
– Off-state open-load detection
– Output short to V_CC detection
– Sense enable/disable
• Protections
– Undervoltage shutdown
– Overvoltage clamp
– Load current limitation
– Self-limiting of fast thermal transients
– Configurable latch-off on overtemperature
or power limitation with dedicated fault
reset pin
– Loss of ground and loss of V_CC
– Reverse battery with external components
– Electrostatic discharge protection
Applications
Typical applications are all types of automotive
resistive, inductive and capacitive loads.
Table 1. Device summary
Order code
Reference
EV-VND7020AJ VND7020AJ evaluation board
September 2015
DocID025740 Rev 5
For further information contact your local STMicroelectronics sales office.
1/7
www.st.com