EV-VND5T100AJ Datasheet, PDF (1/8 Pages) STMicroelectronics – A permanent low level on the inputs and fault

EV-VND5T100AJ
VND5T100AJ evaluation board
Features
Parameter
Symbol Value Unit
Max transient supply voltage V_CC
Operating voltage range
V_CC
Typ On-State resistance
R_ON
Current limitation (typ)
I_LIMH
Off-state supply current
I_S
1. Typical value with all loads connected.
58 V
8 to 36 V
100 mΩ
22 A
2 µA⁽¹⁾
■ Simple single IC application board dedicated
for VND5T100AJ-E
■ Provides thermal heat-sinking for ease of use
in prototyping.
■ Provides electrical connectivity for easy
prototyping
Description
EV-VND5T100AJ provides you an easy way to
connect ST’s surface mounted VIPower^® drivers
into your existing prototype circuitry. This
evaluation board comes pre-assembled with
VND5T100AJ-E high-side driver.
The VND5T100AJ-E is a monolithic device made
using STMicroelectonics^® VIPower^® technology,
intended for driving resistive or inductive loads
with one side connected to ground.
Active V_CC pin voltage clamp protects the device
against low energy spikes. This device integrates
an analog current sense which delivers a current
proportional to the load current.
Fault conditions such as overload,
overtemperature or short to V_CC are reported via
the current sense pin. Output current limitation
protects the device in overload condition. The
device latches off in case of overload or thermal
Data brief − production data
shutdown. The device is reset by a low level pass
on the fault reset standby pin.
A permanent low level on the inputs and fault
reset standby pin disables all outputs and sets the
device in standby mode.
Figure 1. VND5T100AJ evaluation board
Table 1. Device summary
Order code
Reference
EV-VND5T100AJ VND5T100AJ evaluation board
September 2013
Doc ID 023967 Rev 2
This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
1/8
www.st.com
1