|
E-L9823013TR Datasheet, PDF (1/19 Pages) STMicroelectronics – Octal low-side driver for bulb, resistive and inductive loads with serial input control, output protection and diagnostic | |||
|
L9823
Octal low-side driver for bulb, resistive and inductive loads with
serial input control, output protection and diagnostic
Datasheet - production data
'!0'03
SO24
Features
ï· Outputs current capability up to 0.5 A
ï· Cascadable SPI control for outputs
ï· Reset function with reset signal or
undervoltage at VDD
ï· Programmable intrinsic output voltage
clamping at typ. 50 V for inductive switching
ï· Overcurrent shutdown with latch-off for every
write cycle (SFPD = low)
ï· Independent thermal shutdown of outputs
(SOA Protection)
ï· Output status data available on the SPI using
8-bit I/O protocol up to 3.0 MHz
ï· Low standby current with reset = low (typ.
35 µA @ VDD)
ï· Open load detection (outputs off)
ï· Single VDD logic supply
ï· High EMS immunity and low EME (controlled
output slopes)
ï· Full functionality of the remaining device at
negative voltage drop on outputs (-1.5 V or
-3.0 A)
ï· Output mode programmable for sustained
current limit or shutdown
Description
L9823 is a octal low-side driver circuit, dedicated
for automotive applications.
Output voltage clamping is provided for flyback
current recirculation, when inductive loads are
driven.
Chip select and cascadable serial 8-bit Interface
for outputs control and diagnostic data transfer.
Table 1. Device summary
Order code
Package
Packing
L9823
E-L9823
SO24
SO24
Tube
Tube
September 2013
This is information on a product in full production.
DocID7791 Rev 7
1/19
www.st.com
|
▷ |