DEMO-CR95HF-A Datasheet, PDF (1/5 Pages) STMicroelectronics – Microcontroller reset button

DEMO-CR95HF-A
Demonstration kit for the CR95HF 13.56 MHz transceiver IC
Data brief
Features
■ Ready to use printed circuit board
– CR95HF cut 1.2 multiprotocol transceiver
IC
) – STM32F103CB 32-bit microcontroller
t(s ^{– 47 x 34 mm 13.56 MHz inductive etched}
c ^{antenna and tuning components}
u _{– USB-B connector for communication with}
d _{host PC and demonstration board powering}
ro _{– USB connect/disconnect jumper (must be}
P _{left in default state)}
te – LED indicating the presence of an RFID or
le ^{NFC tag}
o _{– Microcontroller reset button}
bs ^{– JTAG connector for microcontroller}
O ^{firmware upgrade and debug}
- _{■ USB cable}
t(s) ^{■ Demonstration tags}
– ISO15693 tag: LRI2K mounted on a
c _{45 x 75 mm antenna}
du _{– ISO 15693 dual interface EEPROM}
ro ^{memory: M24LR64-R mounted on a}
P ^{15 x 15 mm double side etched antenna}
te ^{■ Associated Firmware and PC software}
le ^{– On-board demonstration firmware to}
o^{communicate with the host PC through the}
s_{USB bus.}
Ob^{– The CR95HF developement software}
enable discovery and useof all the
functionalities of the CR95HF transceiver.
– The M24LRXX application software is
dedicated to the Dual interface EEPROM
and ISO/IEC 15693 contactless tag.
September 2012
Doc ID 018756 Rev 3
For further information contact your local STMicroelectronics sales office.
1/5
www.st.com
5