SST25VF016B_13 Datasheet, PDF (4/32 Pages) Silicon Storage Technology, Inc – 16 Mbit SPI Serial Flash

A Microchip Technology Company
Pin Description
16 Mbit SPI Serial Flash
SST25VF016B
Data Sheet
CE#
SO
WP#
VSS
1
8
2
7
Top View
3
6
4
5
VDD
HOLD#
SCK
SI
1271 08-soic S2A P1.0
8-Lead SOIC
Figure 2: Pin Assignments
CE# 1
SO 2
WP# 3
VSS 4
Top View
8 VDD
7 HOLD#
6 SCK
5 SI
1271 08-wson QA P2.0
8-Contact WSON
Table 1: Pin Description
Symbol Pin Name
Functions
SCK Serial Clock
To provide the timing of the serial interface.
Commands, addresses, or input data are latched on the rising edge of the clock
input, while output data is shifted out on the falling edge of the clock input.
SI
Serial Data Input To transfer commands, addresses, or data serially into the device.
Inputs are latched on the rising edge of the serial clock.
SO
Serial Data Output To transfer data serially out of the device.
Data is shifted out on the falling edge of the serial clock.
Outputs Flash busy status during AAI Programming when reconfigured as RY/
BY# pin. See “Hardware End-of-Write Detection” on page 12 for details.
CE# Chip Enable
The device is enabled by a high to low transition on CE#. CE# must remain low for
the duration of any command sequence.
WP# Write Protect
The Write Protect (WP#) pin is used to enable/disable BPL bit in the status regis-
ter.
HOLD# Hold
To temporarily stop serial communication with SPI flash memory without resetting
the device.
V_DD
Power Supply
V_SS
Ground
To provide power supply voltage: 2.7-3.6V for SST25VF016B
T1.0 25044
©2011 Silicon Storage Technology, Inc.
4
DS25044A
08/11