|
SST39LF080_07 Datasheet, PDF (1/25 Pages) Silicon Storage Technology, Inc – 8 Mbit (x8) Multi-Purpose Flash | |||
|
8 Mbit (x8) Multi-Purpose Flash
SST39LF080 / SST39VF080
FEATURES:
SST39LF/VF0803.0 & 2.7V 8Mb (x8) MPF memories
EOL Data Sheet
⢠Organized as 1M x8
⢠Single Voltage Read and Write Operations
â 3.0-3.6V for SST39LF080
â 2.7-3.6V for SST39VF080
⢠Superior Reliability
â Endurance: 100,000 Cycles (typical)
â Greater than 100 years Data Retention
⢠Low Power Consumption
(typical values at 14 MHz)
â Active Current: 12 mA (typical)
â Standby Current: 4 µA (typical)
â Auto Low Power Mode: 4 µA (typical)
⢠Sector-Erase Capability
â Uniform 4 KByte sectors
⢠Block-Erase Capability
â Uniform 64 KByte blocks
⢠Fast Read Access Time:
â 55 ns for SST39LF080
â 70 and 90 ns for SST39VF080
⢠Latched Address and Data
⢠Fast Erase and Byte-Program:
â Sector-Erase Time: 18 ms (typical)
â Block-Erase Time: 18 ms (typical)
â Chip-Erase Time: 70 ms (typical)
â Byte-Program Time: 14 µs (typical)
â Chip Rewrite Time:
15 seconds (typical) for SST39LF/VF080
⢠Automatic Write Timing
â Internal VPP Generation
⢠End-of-Write Detection
â Toggle Bit
â Data# Polling
⢠CMOS I/O Compatibility
⢠JEDEC Standard
â Flash EEPROM Pinouts and command sets
⢠Packages Available
â 40-lead TSOP (10mm x 20mm)
â 48-ball TFBGA (6mm x 8mm)
PRODUCT DESCRIPTION
The SST39LF/VF080 devices are 1M x8 CMOS Multi-Pur-
pose Flash (MPF) manufactured with SSTâs proprietary,
high-performance CMOS SuperFlash technology. The
split-gate cell design and thick-oxide tunneling injector
attain better reliability and manufacturability compared with
alternate approaches. The SST39LF080 write (Program or
Erase) with a 3.0-3.6V power supply. The SST39VF080
write (Program or Erase) with a 2.7-3.6V power supply.
They conform to JEDEC standard pinouts for x8 memories.
Featuring high performance Byte-Program, the SST39LF/
VF080 devices provide a typical Byte-Program time of 14
µsec. The devices use Toggle Bit or Data# Polling to indi-
cate the completion of Program operation. To protect
against inadvertent write, they have on-chip hardware and
Software Data Protection schemes. Designed, manufac-
tured, and tested for a wide spectrum of applications,
these devices are offered with a guaranteed typical
endurance of 10,000 cycles. Data retention is rated at
greater than 100 years.
The SST39LF/VF080 devices are suited for applications
that require convenient and economical updating of pro-
gram, configuration, or data memory. For all system appli-
cations, they significantly improve performance and
reliability, while lowering power consumption. They inher-
ently use less energy during Erase and Program than alter-
native flash technologies. The total energy consumed is a
function of the applied voltage, current, and time of applica-
tion. Since for any given voltage range, the SuperFlash
technology uses less current to program and has a shorter
erase time, the total energy consumed during any Erase or
Program operation is less than alternative flash technolo-
gies. They also improve flexibility while lowering the cost for
program, data, and configuration storage applications.
The SuperFlash technology provides fixed Erase and Pro-
gram times, independent of the number of Erase/Program
cycles that have occurred. Therefore the system software
or hardware does not have to be modified or de-rated as is
necessary with alternative flash technologies, whose Erase
and Program times increase with accumulated Erase/Pro-
gram cycles.
To meet high density, surface mount requirements, the
SST39LF/VF080 are offered in 40-lead TSOP and 48-
ball TFBGA packages. See Figures 1 and 2 for pin
assignments.
©2007 Silicon Storage Technology, Inc.
S71146-07-EOL
6/07
1
The SST logo and SuperFlash are registered trademarks of Silicon Storage Technology, Inc.
MPF is a trademark of Silicon Storage Technology, Inc.
These specifications are subject to change without notice.
|
▷ |