SAT450_15 Datasheet, PDF (5/8 Pages) Solid State Optronic – Ultra Minature 4-Pin Small Outline Package

SAT450 Solder Reflow Temperature Profile Recommendations
SAT450
AC Input
80V
Photo-Transistor Optocoupler
(1) Infrared Reflow:
Refer to the following figure as an example of an optimal temperature profile for single occurrence infrared reflow.
Soldering process should not exceed temperature or time limits expressed herein. Surface temperature of device
package should not exceed 250ºC:
G
F
D
E
H
B
A
C
Process
Step
A
B
C
D
E
F
G
H
Description
Preheat Start Temperature (ºC)
Preheat Finish Temperature (ºC)
Preheat Time (s)
Melting Temperature (ºC)
Time above Melting Temperature (s)
Peak Temperature, at Terminal (ºC)
Dwell Time at Peak Temperature (s)
Cool-down (ºC/s)
(2) Wave Solder:
Maximum Temperature:
Maximum Time:
Pre-heating:
Single Occurrence
260ºC (at terminal)
10s
100 - 150ºC (30 - 90s)
Parameter
150ºC
180ºC
90 - 120s
230ºC
30s
260ºC
10s
<6ºC/s
(3) Hand Solder:
Maximum Temperature:
Maximum Time:
Single Occurrence
350ºC (at tip of soldering iron)
3s
© 2012 Solid State Optronics • San José, CA
www.ssousa.com • +1.408.293.4600
Page 5 of 8
SAT450 /TR
Rev 2.00 (11/30/2012)
001540