SG8050 Datasheet, PDF (4/15 Pages) Solid State Optronic – IGBT Gate Drive Optocoupler

SG8050
0.6A Output Current
IGBT Gate Drive Optocoupler
Electrical Characteristics, continued… T_A = 25°C, V_EE = Ground and V_CC = 30V (unless otherwise specified)
Parameter
Switching Specifications
Propagation Delay Time to
High Output Level
Propagation Delay Time to
Low Output Level
Pulse Width Distortion
Propagation Delay Difference
Between Any Two Parts
Output Rise Time (10 to 90%)
Output Fall Time (90 – 10%)
Symbol Min. Typ. Max. Units Test Conditions
t_PLH
100
300
500
t_PHL
100
300
500
PWD
-
-
300
nS
PDD
-300
-
350
t_r
-
75
-
t_f
-
50
-
I_F = 7 to 16mA
V_CC = 15 to 30V
V_EE = Ground
Rg = 10Ω
Cg = 10nF
f = 10kHz
Duty Cycle = 50%
Fig. Notes
10
11
12
13
14
7
23
4
23
UVLO Turn On Delay
t_{UVLO ON}
-
2
-
S
I_F = 10mA, V_O > 5V
UVLO Turn Off Delay
t_{UVLO OFF}
-
0.3
Common Mode Transient Immunity at
HIGH Level Output
| CM_H |
15
25
Common Mode Transient Immunity at
LOW Level Output
| CM_L |
15
25
-
S
I_F = 10mA, V_O < 5V
I_F = 7 to 16mA
-
kV/S
V_CM = 1500V
T_A = 25°C
V_CC = 30V
V_F = 0V
-
kV/S
V_CM = 1500V
T_A = 25°C
V_CC = 30V
5
24
6
Notes
1. Maximum pulse width = 10S, maximum duty cycle = 0.2%
2. Device is considered a two-terminal device: pins 1, 2, 3, and 4 shorted together, and pins 5, 6, 7, and 8 shorted together
3. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage ≥6000 V_RMS for one second (leakage
current less than 5 A)
4. The difference between T_PHL and T_PLH between any two SG8050 devices under the same test conditions
5. Common mode transient immunity in HIGH stage is the maximum tolerable negative dV_CM/dt on the trailing edge of the common mode
impulse signal, V_CM, to assure that the output will remain HIGH
6. Common mode transient immunity in LOW stage is the maximum tolerable positive dV_CM/dt on the leading edge of the common mode
impulse signal, V_CM, to assure that the output will remain LOW
7. Pulse Width Distortion is defined as |T_PHL – | T_PLH for any given device
8. 260°C for 10 seconds. Refer to the lead free solder reflow profile for more information
9. Derate linearly above 70°C free air temperature at a rate of 0.47mW / °C
10. Derate linearly above 70°C free air temperature at a rate of 4.8mW / °C
© 2015 Solid State Optronics • San José, CA
www.ssousa.com • +1.408.293.4600
Page 4 of 15
SG8050 /H/S/TR
Rev03 (02/02/2015)
002351