SDS6011 Datasheet, PDF (1/8 Pages) Solid State Optronic – Schmitt Trigger Optocoupler

SDS6011
DC Input
1MHz
Schmitt Trigger Optocoupler
Description
The SDS6011 consists of a light emitting diode optically
coupled to an output integrated circuit detector. The
output circuit integrates an optical coupler and a Schmitt
Trigger providing hysteresis for noise immunity and pulse
shaping. Optical coupling between the input IR LED and
output structure allows for high isolation levels while
maintaining low-level DC signal control capability. An open
collector output allows further design flexibility.
The SDS6011 comes standard in a miniature 6 pin DIP
package.
Applications
 Logic to Logic Isolator
 Programmable Current Level Sensor
 Line Receiver (eliminate noise & transients)
 A.C. to TTL Conversion (square wave shaping)
 Digital Programming of Power Supplies
 Interfacing PCs with Peripherals
Schematic Diagram
Anode 1
6 V_CC
Cathode 2
5 Ground
Features
 High data date – 1MHz (NRZ)
 Free from latch up and oscillation
 Microprocessor compatible Drive
 Logic compatible output sinks 16mA @ 0.4V
 Guaranteed on/off threshold hysteresis
 High common mode rejection ratio
 Fast switching (100nS typical t_R and t_F)
 Wide supply voltage compatibility
Agency Approvals
UL/C-UL:
VDE:
File # E201932
File # 40035191 (EN 60747-5-2)
Absolute Maximum Ratings
The values indicated are absolute stress ratings. Functional
operation of the device is not implied at these or any
conditions in excess of those defined in electrical
characteristics section of this document. Exposure to
absolute Maximum Ratings may cause permanent damage
to the device and may adversely affect reliability.
Storage Temperature …………………………..-55 to +150°C
Operating Temperature ………………………-40 to +85°C
Continuous Input Current ………………………………..60mA
Transient Input Current ………………….……………..500mA
Reverse Input Control Voltage …………..…………………5V
Input Power Dissipation ………………………………100mW
Total Power Dissipation ……………………………..400mW
Solder Temperature – Wave (10sec)……………….….260°C
Solder Temperature – IR Reflow (10sec)….…………..260°C
Do Not Connect 3
SDS6011
© 2013 Solid State Optronics • San José, CA
www.ssousa.com • +1.408.293.4600
4 V_O
Ordering Information
Part Number Description
SDS6011
SDS6011-H
SDS6011-S
SDS6011-STR
6 pin DIP, (60/Tube)
0.40” (10.16mm) Lead Spacing (VDE0884)
6 pin SMD, (60/Tube)
6 pin SMD, Tape and Reel (1000/Reel)
NOTE: Suffixes listed above are not included in marking on
device for part number identification
Page 1 of 8
SDS6011 H/S/TR
Rev 1.00 (10/31/2013)
001664