AD6C332 Datasheet, PDF (1/5 Pages) Solid State Optronic – 1 Form B Solid State Relay

AD6C332
1 Form B
Solid State Relay
DESCRIPTION
The AD6C332 is a bi-directional, single-pole, single-throw, normally closed multipurpose solid-state relay. It is designed to replace
electromechanical relays in general purpose switching applications. The relay consists of an integrated circuit that drives two rugged
source-to-source depletion type DMOS transistors - optically coupled to a light emitting diode. The output MOS transistors are protected
with free-wheeling diodes that can handle up to 5A of inrush current, making the relay ideal for switching lamps and highly inductive loads.
FEATURES
• ^{Low On-resistance (10 Ohms MAX)}
• ^{Low input control power consumption (2.5mA TYP)}
• ^{200mA maximum continuous load current}
• ^{High input-to-output isolation}
• ^{Long life/high reliability}
OPTIONS/SUFFIXES*
• ^{-S Surface Mount Leadform Option}
• ^{-TR Tape and Reel Option}
NOTE: Suffixes listed above are not included in marking on
device for part number identification.
SCHEMATIC DIAGRAM
APPLICATIONS
• ^{Reed relay replacement}
• ^{Meter reading systems}
• ^{Medical equipment}
• ^{Battery monitoring}
• ^Multiplexers
ABSOLUTE MAXIMUM RATINGS*
PARAMETER
UNIT MIN TYP MAX
Storage Temperature
°C -55
125
Operating Temperature
°C -40
85
Continuous Input Current mA
40
Transient Input Current
mA
400
Reverse Input Control
Voltage
V
6
Output Power Dissipation mW
800
*The values indicated are absolute stress ratings. Functional operation of the
device is not implied at these or any conditions in excess of those defined in
electrical characteristics section of this document. Exposure to Absolute
Ratings may cause permanent damage to the device and may adversely
affect reliability.
APPROVALS
• ^{BABT CERTIFICATE #607836}
BS EN 60950, BS EN 41003, BS EN 60065
• ^{CSA CERTIFICATE #LR111581-1}
© 2004 Solid State Optronics • San José, CA
www.ssousa.com • +1.408.293.4600
Page 1 of 5
AD6C332
rev 1.40 (10/25/2004)