AD6C101 Datasheet, PDF (1/5 Pages) Solid State Optronic – 1 Form A Solid State Relay

AD6C101
1 Form A
Solid State Relay
DESCRIPTION
The AD6C101 is a bi-directional, single-pole, single-throw, normally open multipurpose solid-state relay. With a high blocking voltage
(600V), it is designed to replace electromechanical relays in high voltage switching applications. The relay consists of an integrated circuit
that drives two rugged source-to-source enhancement type DMOS transistors - optically coupled to a light emitting diode. The output
MOS transistors are protected with free-wheeling diodes that can handle up to 1.5A of inrush current, making the relay ideal for switching
lamps and highly inductive loads.
FEATURES
APPLICATIONS
• ^{High Blocking Voltage (600V)}
• ^{High Input-Output Isolation (3750V)}
• ^{120mA MAX Continuous Load Current}
• ^{On Resistance 40 ohms MAX}
• ^{Long Life/High Reliability}
• ^{Reed relay replacement}
• ^{Meter reading systems}
• ^{Medical equipment}
• ^{Battery monitoring}
• ^Multiplexers
OPTIONS/SUFFIXES*
ABSOLUTE MAXIMUM RATINGS*
• ^{-H High Input-to-Output Isolation}
• ^{-S Surface Mount Leadform Option}
• ^{-TR Tape and Reel Option}
NOTE: Suffixes listed above are not included in marking on
device for part number identification.
PARAMETER
UNIT MIN TYP MAX
Storage Temperature
°C -55
125
Operating Temperature
°C -40
85
Continuous Input Current mA
50
SCHEMATIC DIAGRAM
Transient Input Current
mA
400
Reverse Input Control
Voltage
V
6
Output Power Dissipation mW
600
*The values indicated are absolute stress ratings. Functional operation of the
device is not implied at these or any conditions in excess of those defined in
electrical characteristics section of this document. Exposure to Absolute
Ratings may cause permanent damage to the device and may adversely
affect reliability.
© 2004 Solid State Optronics • San José, CA
www.ssousa.com • +1.408.293.4600
Page 1 of 5
AD6C101
rev 1.40 (10/25/2004)