TVS-TECA Datasheet, PDF (1/4 Pages) StarHope – Surface Mount Transient Voltage Suppressor Stand-Off Voltage - 6.0 to 440 Volts 400 Watt Peak Pulse Power

SPSEMI
TECA(400W) Series
Surface Mount Transient Voltage Suppressor
Stand-Off Voltage - 6.0 to 440 Volts
400 Watt Peak Pulse Power
Features
For surface mounted applications in order to optimize board space
Low profile package
Built-in strain relief
Glass passivated junction
Low inductance
Excellent clamping capability
Repetition Rate (duty cycle):0.01%
Fast response time: typically less than 1.0ps from 0 Volts to V(BR)
for unidirectional types
Typical IR less than 1µA above 10V
High Temperature solderting: 260°C/10 seconds at terminals
Plastic package has Underwriters Laboratory Flammability 94V-O
Pb-free plated
Mechanical Data
Case: JEDEC SOD-123FL molded plastic over passivated chip
Terminals: Solder plated, solderable per MIL-STD-750 Method 2026
Polarity: For uni-directional types the bandby laser denotes the cathode, which is positive with respect to
the anode under normal TVS operation
Devices For Bipolar Application
For Bidirectional use C or CA Suffix for types TECA6.0 thru types TECA440 (e.g. TECA6.0C , TECA440CA)
Electrical characteristics apply in both directions
Maximum Ratings And Characteristics
Ratings at 25℃ambient temperature unless otherwise specified.
RATING
SYMBOL VALUE
UNITS
Peak Pulse Power Dissipation on 10/1000µs waveform
(Note 1,2 ,FIG.1)
Peak Pulse Current of on 10/1000µs waveform (Note 1,FIG.3)
Peak Forward Surge Current,8.3ms Single Half Sine-Wave
Superimposed on Rated Load,(JEDEC Method) (Note2,3)
Operating junction and Storage Temperature Range
PPPM
IPPM
IFSM
TJ , TSTG
Minimum
400
SEE
TABLE 1
20
-55 to
+150
Watts
Amps
Amps
℃
Notes :
1.Non-repetitive current pulse , per Fig. 3 and derated above TA = 25℃ per Fig. 2 .
2.Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal
3.8.3ms single half sine-wave , or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.
REV .2017.03 .01
www.spsemi.cn
Page 1 of 4