TVS-5SMDJ Datasheet, PDF (1/5 Pages) StarHope – Surface Mount Transient Voltage Suppressor Stand-Off Voltage - 11 to 170 Volts 5000 Watt Peak Pulse Power

SPSEMI
5.0SMDJ(5000W) Series
Surface Mount Transient Voltage Suppressor
Stand-Off Voltage - 11 to 170 Volts
5000 Watt Peak Pulse Power
Features
For surface mounted applications in order to optimize board space
Low profile package
Built-in strain relief
Glass passivated junction
Low inductance
Excellent clamping capability
Repetition Rate (duty cycle):0.01%
Fast response time: typically less than 1.0ps from 0 Volts to V(BR)
for unidirectional types
Typical IR less than 2µA
High Temperature solderting: 260°C/10 seconds at terminals
Plastic package has Underwriters Laboratory Flammability 94V-O
Pb-free plated
Mechanical Data
Case: JEDEC DO-214AB. Molded plastic over glass passivated junction
Terminals: Solderable per MIL-STD-750,Method 2026
Polarity: Color band denoted positive end (cathode) except Bidirectional
Standard Packaging:16mm tape (EIA STD RS-481)
Weight:0.007ounce,0.21gram
Maximum Ratings And Characteristics
Ratings at 25℃ambient temperature unless otherwise specified.
RATING
SYMBOL VALUE
UNITS
Peak Pulse Power Dissipation on 10/1000µs waveform
(Note 1,2 ,FIG.1)
Peak Pulse Current of on 10/1000µs waveform (Note 1,FIG.3)
Peak Forward Surge Current,8.3ms Single Half Sine-Wave
Superimposed on Rated Load,(JEDEC Method) (Note2,3)
Operating junction and Storage Temperature Range
PPPM
IPPM
IFSM
TJ , TSTG
Minimum
5000
SEE
TABLE 1
300
-55 to
+150
Watts
Amps
Amps
℃
Notes :
1.Non-repetitive current pulse , per Fig. 3 and derated above TA = 25℃ per Fig. 2 .
2.Mounted on 8.0mm x 8.0mm Copper Pads to each terminal
3.8.3ms single half sine-wave , or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.
REV.2016.08.10
www.spsemi.cn
Page 1 of 5