|
SPI650ACAP Datasheet, PDF (1/1 Pages) Sparkle Power Inc. – Complied with ATX12V 2.3 standard | |||
|
Sparkle Power Inc.
A Leading Power Supply
Manufacturer Website:
www.sparklepower.com
SPI650ACAP
(80PLUS Platinum, RoHS Compliant)
650 Watts ATX12V 2.3 EPS12V V2.92 Switching
Power Supply (Meet 2013 ErP)
Features
Specification
ï· Complied with ATX12V 2.3 standard
ï· Active Power Factor Correction (PFC) meet EN61000-3-2
ï· High efficiency and reliability
ï· Compatible with European Union Directive 2002/95/EC (Restriction
on Hazardous Substances).
ï· Remote ON/OFF function
ï· Internal 12V DC fan included
ï· Noise Killer (thermal fan speed control function)
ï· Low noise and ripple
ï· Output over voltage, short circuit, and over current protection
ï· 100% Hi-pot, ATE, and burn-in tested
ï· Re-settable power shut down
ï· Complies with FCC part 15 subpart J class B 115Vac operation, and
CISPR 22 class B at 230Vac operation
ï· Approved by CUL/UL60950-1, TUV EN60950-1,CB 60950-1 report,
FCC,EMC.
ï· Temperature Range: Operating: +0°C ~ +40°C on full load
Storage & Shipping: -40°C ~ +70°C
ï· Humidity: 5-85% on operating, 5-95% on storage
ï· Dielectric Withstand: Primary to frame ground 1800VAC for 1
second
ï· Efficiency: 89% minimum, typical up to 92%
ï· Rise time: 15ms maximum
ï· Hold-up Time: 17ms minimum at nominal input voltage
ï· Power Good Signal: Power on delay time 100 ~ 500ms, off delay
1ms minimum (TTL and CMOS compatible)
ï· Leakage Current: Less than 3.5mA at 264Vac, 50Hz
ï· MTBF: 100,000 hours on maximum load at +25°C
ï· Dimensions (LxWxH):140x150x85.8mm / 5.5x5.9x3.4inch
Input Characteristics
Input Range: 90 ~ 264Vac, Full Range Input
Frequency: 47 ~ 63Hz
Input Current: Max 10A at 100-127Vrms@60Hz,
Max 5A at 200-240Vrms@50Hz
Inrush Current: No damage.
Output Characteristics
*+3.3V & +5V total output does not exceed 105W
when +5V is loaded to 18A, then +3.3V maximum load is 4.5A
when +3.3V is loaded to20A, then +5V maximum load is 7.8A
*+12V1, +12V2,+12V3 total output not exceed 576W(48A)
*All outputs shall be safety-isolated from the AC mains and share
a common return. This common return must be connected to
supply chassis
*Voltage and ripple are measured at the load side of mating
connectors with a 0.1uF monolithic ceramic capacitor paralleled
by a 10uF electrolytic capacitor across the measuring terminals
Sparkle Power Inc.
Main Office
1000 Rock Avenue
San Jose, CA 95131
TEL: 408-519-8888
FAX: 408-519-9999
E-MAIL: info@sparklepower.com
Sparkle Power Inc.
Los Angeles Office
17071 Green Drive
City of Industry, CA 91745
TEL: 626-839-7180
FAX: 626-839-3395
|