English
Language : 

R-FSP500-70ETN Datasheet, PDF (1/1 Pages) Sparkle Power Inc. – 500 Watts ATX12V V2.3 EPS12V V2.92 Switching Power Supply
Sparkle Power Inc.
A Leading Power Supply
Manufacturer
www.sparklepower.com
R-FSP500-70ETN
(80PLUS Platinum, RoHS Compliant)
500 Watts ATX12V V2.3 EPS12V V2.92 Switching
Power Supply (Meet 2013 ErP)
Features
• Complied with ATX12V V2.3 EPS12V V2.92 standard
• Active Power Factor Correction (PFC) meet EN61000-3-2
• High efficiency and reliability
• Compatible with European Union Directive 2002/95/EC (Restriction
on Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Low noise and ripple
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation, and
CISPR 22 class B at 230Vac operation
• Approved by CUL/UL60950-1, TUV EN60950-1,CB 60950-1 report,
FCC,EMC.
Input Characteristics
Input Range: 90 ~ 264Vac, Full Range Input
Frequency: 47 ~ 63Hz
Input Current: 8 Amp (maximum) at 100-127Vrms/ 60 Hz
4Amp (maximum) at 200-240 Vrms/ 50 Hz.
Inrush Current: No damage.
Output Characteristics
Specification
• Temperature Range: Operating: +0°C ~ +40°C on full load
Storage & Shipping: -40°C ~ +70°C
• Humidity: 5-85% on operating, 5-95% on storage
• Efficiency: 89% minimum, typical up to 92%
• Rise time: 15ms maximum
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay
1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA at 264Vac, 50Hz
• MTBF: 100,000 hours on maximum load at +25°C
• Dimensions (LxWxH):140x150x85.8mm / 5.5x5.9x3.4inch
+3.3V
+5V
+12V1
+12V2
+12V3
-12V
+5Vsb
MINIMUM
LOAD
0.1A
0.2A
0.1A
0A
0A
0A
0A
NORMAL
LOAD
12A
12A
8A
8A
8A
0.15A
1.5A
MAXIMUM
LOAD
16/3A
7.4/16A
18A
18A
18A
0.3A
3A
LOAD
REG.
±5%
±5%
±5%
±5%
±5%
±10%
±5%
LINE
REG.
±1%
±1%
±1%
±1%
±1%
±2%
±1%
RIPPLE & NOISE
50mV P-P
50mV P-P
120mV P-P
120mV P-P
120mV P-P
200mV P-P
50mV P-P
(1) +3.3V & +5V total output not exceed 90W.
When +5V is load to 16A, the +3.3V maximum load is 3A.
When +3.3V is load to 16A, the +5V maximum load is 7.4A.
(2) +12V1 & +12V2& +12V3 total output not exceed 456W(38A).
(3) All outputs shall be safety-isolated from the AC mains and share a
common
return. This common return must be connected to supply chassis.
(4) Voltages and ripple are measured at the load side of mating
connectors with a
0.1uF monolithic ceramic capacitor paralleled by a 10uF electrolytic
capacitor
Sparkle Power Inc.
Main Office
1000 Rock Avenue
San Jose, CA 95131
Tel : 408-519-8888
Fax: 408-519-9999
E-MAIL: info@sparklepower.com
Sparkle Power Inc.
Los Angeles Office
17071 Green Drive
City of Industry, CA 91745
Tel : 626-839-7180
Fax: 626-839-3395