CZ8110 Datasheet, PDF (1/1 Pages) Spectrum Microwave, Inc. – RF AMPLIFIER

RF AMPLIFIER
MODEL CZ8110
Available as: CZ8110, 3 Pin TO-39 (T10)
Features
! Replacement for the Motorola MWA 110
! Low Noise Figure: <4 dB Typical
! Operating Temp. 0 ºC to +70 ºC
! Environmental Screening Available
Typical Intermodulation Performance at 25 º C
Second Order Harmonic Intercept Point ...... +15 dBm (Typ.)
Second Order Two Tone Intercept Point ....... + 8 dBm (Typ.)
Third Order Two Tone Intercept Point ........... +10 dBm (Typ.)
Specifications
CHARACTERISTIC
Frequency
TYPICAL
Ta= 25 ºC
kHz - 400 MHz
MIN/MAX
Ta = 0 ºC to +70 ºC
kHz - 400 MHz
Gain (dB)
15
13.0 Min.
Power @ 1 dB
Comp. (dBm)
-0.2
Reverse
Isolation (dB)
-19
-5.0 Min.
-18 Max.
VSWR
In
Out
<1.5:1
<2.0:1
2.5:1 Max.
2.5:1 Max.
Noise figure (dB)
<4.0
5.5 Max.
Power
Vdc
+3
+3
mA
10
12 Max.
Note: Care should always be taken to effectively ground the case of each unit.
Maximum Ratings
Ambient Operating Temperature .............. -55ºC to + 100 ºC
Storage Temperature ............................... -62ºC to + 125 ºC
Case Temperature ................................................. + 125 ºC
DC Current .............................................................. 25 mA
Continuous RF Input Power ................................... + 6 dBm
Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.)
Maximum Peak Power ................... 0.5 Watt ( 3 µsec Max.)
* Decoupling Impedance is 1 kOhm
17
16
15
14
13 _{Start kHz}
Gain (dB)
Stop 400 MHz
Typical Performance Data
Reverse Isolation (dB)
0
- 10
- 20
- 30
- 40
Start kHz
Stop 400 MHz
6
5
4
3
2
Start kHz
Noise Figure (dB)
Stop 400 MHz
1 dB Comp. (dBm)
+2
0
-2
-4
-6
Start kHz
Stop 400 MHz
2.0
1.5
1.0
Start kHz
Input VSWR
3.0
Output VSWR
2.0
Stop 400 MHz
1.0
Start kHz
Stop 400 MHz
Legend
+25 ºC
+70 ºC - - - - - - 0 ºC
The CZ82X0 Series Amplifiers are designed for application in 50 ohm
systems. Three external capacitors and a decoupling impedance are
required. The decoupling impedance must be large in comparison to
the 50 ohm load to minimize gain reduction. Data sheet curves are
based on the noted decoupling impedance. The external capacitors
determine the low frequency recponse of the Amplifier.
The CZ82X0 Series Amplifiers can be cascaded in series of two or
more units without oscillation problems.
50 Ohm Input
Application Information
Schematic Diagram
+Vcc
CZ Series Amp
Decoupling
Impedance
50 Ohm Output
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]^/04
www.SpectrumMicrowave.com ^{Spectrum Microwave (Europe) · 2707 Black Lake Place · Philadelphia, Pa. 19154 · PH [phone] · Fax [phone]}