DEV-13995 Datasheet, PDF (1/2 Pages) SparkFun Electronics – Teensy Prop Shield



Teensy Prop Shield
DEV-13995 ROHS 
Page 1 of 2
Description: The Teensy Prop Shield is meant for making interactive light and sound
effects on small, handheld props and wearable costumes. This shield features 10DoF
(Degrees of Freedom) motion sensors, a 2W audio amp, high-speed 5V buffers for
driving APA102 LEDs, and an 8MB flash memory. This little board is about the size of
the Teensy 3.2, just slightly longer to allow space for mounting holes and connections
for power, speaker and LEDs.
The Teensy Prop Shield’s crowning glory is, of course, its Freescale 10DoF sensors.
The board’s sensor suite comprises an FXOS8700CQ 6-axis linear accelerometer
and magnetometer, an FXAS21002C 3-axis digital angular rate gyroscope and an
MPL3115A2 precision pressure/altitude and temperature gauge.
That’s not all! The Teensy Prop Shield has been equipped with a slew of other
features. Need an amplifier? The Teensy Prop Shield has one rated at 2W and is
capable of driving 4 or 8 Ohm speakers. Additionally, the Prop Shield has 5V buffers
meant to send data to Dotstar or APA102 type addressable LEDs. It also has an
onboard 8MB flash memory, meant for storing sound clips and images, logging data
and many other uses.
Note: If you are looking for a more economical board than this version of the Prop
Shield, be sure to check out the low-cost (LC) version instead!