DEV-13040 Datasheet, PDF (1/5 Pages) SparkFun Electronics – SparkFun Blocks for Intel® Edison - UART Block



Page 1 of 5
SparkFun Blocks for Intel® Edison - UART
Block
Introduction
The UART Block provides a level shifted interface to the console port or
second UART port. This is a great solution when USB is not an option. This
allows the Edison module to be interfaced with legacy hardware by
providing a protected signal interface. Using a RS232 Shifter, it is possible
to connect an Edison to RS232 devices commonly found in older
automation equipment and instrumentation. The UART Block paired with a
5V Compatible FTDI device, such as our FTDI Basic Breakout, will power
an Edison Stack.
UART Block
Suggested Reading
If you are unfamiliar with Blocks, take a look at the General Guide to
Sparkfun Blocks for Intel Edison.
Other tutorials that may help you on your Edison adventure include:
• Serial Communication
• How to Install FTDI Drivers
• Serial Terminal Basics
• Powering Your Project
• Connector Basics
Board Overview