DEV-11018 Datasheet, PDF (1/9 Pages) SparkFun Electronics – Shield Landing Page



Page 1 of 9
RFM22 Shield Landing Page
Overview:
Skill Level:  Beginner
The RFM22 shield is an Arduino-compatible shield which provides a means to
communicate with the HOPERF RFM22 radio transceiver module. What does THAT
mean? It means you can use the RFM22 shield to add wireless communications to
your Arduino projects.
This tutorial will give you the information you need to assemble your shield and start
using it.
Requirements:
You'll need at least two RFM22 modules to set up communications- the RFM22 is not
compatible with other wireless modules on the market, such as XBee, Bluetooth or
the RFM12. You'll also need to make sure that your kit is complete- check the list
below to see if all the necessary parts came in your package:
• 1 x pre-assembled RFM22 shield PCB. Compare to the picture above to make
sure everything is in the right place.
• 2 x long-pin 1x8 female headers
• 2 x long-pin 1x6 female headers
• 1 x 5" wire (22ga solid)