|
DEV-10182 Datasheet, PDF (1/1 Pages) SparkFun Electronics – SparkFun Monster Moto Shield | |||
|
î
SparkFun Monster Moto Shield
DEV-10182 ROHSî
î©î©î©î©î©1
î images are CC BY-NC-SA 3.0
Description: This is essentially a ramped up version of our Ardumoto motor driver
shield. For this SparkFun Monster Moto Shield weâve replaced the L298 H-bridge with
a pair of VNH2SP30 full-bridge motor drivers. Weâve also beefed up the support
circuitry so this board is capable of driving a pair of high-current motors! The VIN and
motor out are pitched for our 5mm screw terminals (not included), making it easy to
connect larger gauge wires.
Note: When using this board in extreme high-demand applications it may be
necessary to improve thermal performance with a heat-sink or fan and to solder the
wires directly to the board instead of using a screw terminal (in addition to the myriad
other complications present in a high-current system) However, when using the board
at currents up to 6A the chips will barely become noticeably warm.
Features:
⢠Voltage max: 16V
⢠Maximum current rating: 30 A
⢠Practical Continuous Current: 14 A
⢠Current sensing available to Arduino analog pin
⢠MOSFET on-resistance: 19 mΩ (per leg)
⢠Maximum PWM frequency: 20 kHz
⢠Thermal Shutdown
⢠Undervoltage and Overvoltage shutdown
https://www.sparkfun.com/products/10182
10/12/2015
|