S29PL-J_12 Datasheet, PDF (76/99 Pages) SPANSION – 128/128/64/32 Megabit (8/8/4/2M x 16-Bit) CMOS 3.0 Volt-Only, Simultaneous-Read/Write Flash Memory with Enhanced VersatileIO™ Control

Data Sheet
V_IO
0.0 V
Input
Figure 20.2 Input Waveforms and Measurement Levels
V_IO/2
Measurement Level
V_IO/2
Output
20.3
Read Operations
Table 20.3 Read-Only Operations
Parameter
JEDEC Std.
t_AVAV
t_AVQV
t_ELQV
t_GLQV
t_EHQZ
t_GHQZ
t_RC
t_ACC
t_CE
t_PACC
t_OE
t_DF
t_DF
t_AXQX
t_OH
t_OEH
Description (Notes)
Read Cycle Time (1)
Address to Output Delay
Chip Enable to Output Delay
Page Access Time
Output Enable to Output Delay
Chip Enable to Output High Z (3)
Output Enable to Output High Z (1, 3)
Output Hold Time From Addresses,
CE# or OE#, Whichever Occurs First (3)
Output Enable Hold Time (1)
Read
Toggle and Data# Polling
Speed Options
Test Setup
55 60 65 70 Unit
Min 55 60 65 70 ns
CE#, OE# = V_IL Max 55 60 65 70 ns
OE# = V_IL
Max 55 60 65 70 ns
Max 20 25 25 30 ns
Max 20 25 30
ns
Max
16
ns
Max
16
ns
Min
5
ns
Min
0
ns
Min
10
ns
Notes
1. Not 100% tested.
2. See Figure 20.1 on page 75 and Table 20.1 on page 75 for test specifications
3. Measurements performed by placing a 50 ohm termination on the data pin with a bias of V_CC /2. The time from OE# high to the data bus
driven to V_CC /2 is taken as t_DF.
4. S29PL129J has two CE# (CE1#, CE2#).
5. Valid CE1# / CE2# conditions: (CE1# = V_IL,CE2# = V_IH) or (CE1# = V_IH,CE2# = V_IL) or (CE1# = V_IH, CE2# = V_IH)
6. Valid CE1# / CE2# transitions: (CE1# = V_IL,CE2# = V_IH) or (CE1# = V_IH,CE2# = V_IL) to (CE1# = CE2# = V_IH)
7. Valid CE1# / CE2# transitions: (CE1# = CE2# = V_IH) to (CE1# = V_IL,CE2# = V_IH) or (CE1# = V_IH,CE2# = V_IL)
8. For 70 pF Output Load Capacitance, 2 ns will be added to the above t_ACC,t_CE,t_PACC,t_OE values for all speed grades
Addresses
CE#
OE#
WE
Data
Figure 20.3 Read Operation Timings
t_RC
Addresses Stable
t_ACC
t_RH
t_RH
t_OEH
High Z
t_OE
t_CE
t_D
t_OH
Valid Data
High Z
RESET#
RY/BY# _{0 V}
Notes
1. S29PL129J - During CE1# transitions, CE2# = V_IH; During CE2# transitions, CE1# = V_IH
2. S29PL129J - There are two CE# (CE1#, CE2#). In the above waveform CE# = CE1# or CE2#
Figure 20.4 Page Read Operation Timings
76
S29PL-J
S29PL-J_00_A15 March 14, 2012