S75PL127J Datasheet, PDF (74/183 Pages) SPANSION – Power supply woltage of 2.7 to 3.1 volt

Preliminary
Parameter
Sector Erase Time
Chip Erase Time
Table 25. Erase And Programming Performance
PL127J
PL064J
PL032J
Typ (Note 1)
0.5
135
71
39
Max (Note 2)
2
216
113.6
62.4
Unit
sec
sec
sec
sec
Word Program Time
6
100
µs
Accelerated Word Program Time
Chip Program Time
(Note 3)
PL127J
PL064J
PL032J
4
50.4
25.2
12.6
60
µs
200
sec
50.4
sec
25.2
sec
Comments
Excludes 00h programming
prior to erasure (Note 4)
Excludes system level
overhead (Note 5)
Notes:
1. Typical program and erase times assume the following conditions: 25×C, 3.0 V V_CC, 100,000 cycles. Additionally,
programming typicals assume checkerboard pattern. All values are subject to change.
2. Under worst case conditions of 90×C, V_CC = 2.7 V, 100,000 cycles. All values are subject to change.
3. The typical chip programming time is considerably less than the maximum chip programming time listed, since most
bytes program faster than the maximum program times listed.
4. In the pre-programming step of the Embedded Erase algorithm, all bytes are programmed to 00h before erasure.
5. System-level overhead is the time required to execute the two- or four-bus-cycle sequence for the program
command. See Table 13 for further information on command definitions.
6. The device has a minimum erase and program cycle endurance of 100,000 cycles.
BGA Pin Capacitance
Parameter Symbol
C_IN
C_OUT
C_IN2
C_IN3
Parameter Description
Input Capacitance
Output Capacitance
Control Pin Capacitance
WP#/ACC Pin Capacitance
Notes:
1. Sampled, not 100% tested.
2. Test conditions T_A = 25°C, f = 1.0 MHz.
Test Setup
V_IN = 0
V_OUT = 0
V_IN = 0
V_IN = 0
Typ Max Unit
6.3
7
pF
7.0
8
pF
5.5
8
pF
11
12
pF
August 12, 2004 S29PL127J_064J_032J_MCP_00_A3 S29PL127J/S29PL064J/S29PL032J for MCP
75