S29AL016J70BFI010 Datasheet, PDF (41/58 Pages) SPANSION – 16 Megabit (2 M x 8-Bit/1 M x 16-Bit) CMOS 3.0 Volt-only Boot Sector Flash Memory

Data Sheet
14. DC Characteristics
14.1
CMOS Compatible
Parameter
Description
Test Conditions
Min
Typ
Max
Unit
Input Load Current
I_LI
WP# Input Load Current
I_LIT
A9 Input Load Current
I_LO
Output Leakage Current
I_CC1
V_CC Active Read Current
(Note 1)
V_IN = V_SS to V_CC, V_CC = V_{CC max}
V_CC = V_{CC max}, WP# = V_SS to V_CC
V_CC = V_{CC max}; A9 = 12.5 V
V_OUT = V_SS to V_CC,
V_CC = V_{CC max}
CE# = V_IL, OE# ₌ V_IH,
V_CC = V_{CC max}, Byte Mode
5 MHz
1 MHz
CE# = V_IL, OE# ₌ V_IH,,
V_CC = V_{CC max}, Word Mode
5 MHz
1 MHz
±1.0
±25
35
µA
±1.0
7
12
2
4
mA
7
12
2
4
I_CC2
I_CC3
V_CC Active Erase/Program Current
(Notes 2, 3, 4)
V_CC Standby Current (Note 4)
CE# = V_IL, OE# = V_IH,
V_CC = V_{CC max}
OE# = V_IH,
CE#, RESET# = V_CC + 0.3 V/-0.1V,
WP# = V_CC or open, V_CC = V_{CC max}
(Note 5)
20
30
mA
0.2
5
µA
I_CC4
V_CC Standby Current During Reset
(Note 4)
V_CC = V_{CC max};
RESET# = V_SS + 0.3 V/-0.1V
WP# = V_CC or open, (Note 5)
0.2
5
µA
I_CC5
Automatic Sleep Mode
(Notes 3, 4)
V_CC = V_{CC max}, V_IH = V_CC + 0.3 V,
V_IL = V_SS + 0.3 V/-0.1 V,
WP# = V_CC or open, (Note 5)
0.2
5
µA
V_IL
Input Low Voltage
-0.1
0.8
V_IH
Input High Voltage
0.7 x V_CC
V_CC + 0.3
V_ID
Voltage for Autoselect and Temporary
Sector Unprotect
V_CC = 2.7–3.6 V
V_OL
Output Low Voltage
I_OL = 4.0 mA, V_CC = V_{CC min}
8.5
12.5
0.45
V
V_OH1
V_OH2
Output High Voltage
I_OH = -2.0 mA, V_CC = V_{CC min}
I_OH = -100 µA, V_CC = V_{CC min}
0.85 x V_CC
V_CC–0.4
V_LKO Low V_CC Lock-Out Voltage
2.1
2.5
Notes
1. The I_CC current listed is typically less than 2 mA/MHz, with OE# at V_IH. Typical V_CC is 3.0 V.
2. I_CC active while Embedded Erase or Embedded Program is in progress.
3. Automatic sleep mode enables the low power mode when addresses remain stable for t_ACC + 30 ns.
4. Not 100% tested.
5. When the device is operated in Extended Temperature range, the currents are as follows:
I_CC3 = 0.2 µA (typ), 10 µA (max)
I_CC4 = 0.2 µA (typ), 10 µA (max)
I_CC5 = 0.2 µA (typ), 10 µA (max)
April 12, 2012 S29AL016J_00_12
S29AL016J
41