ITR-D3T-SD6-2 Datasheet, PDF (9/10 Pages) Source Photonics, Inc. – 1310/1490/1555nm Integrated Triplexer Transceiver

ITR-D3T-SD6-2
Ordering Information
Table 8 - Ordering Information
ITx
-
x Application Type x PON Standard
xyz
y Tx Rate
-
xy
z
-x-
z Rx Rate
xy Customer z Platform Revision
x
Supplemental
Integrated Triplexer,
R
Residential Application
BPON, Class B, SC/APC
B
1
155Mbps
T
2x Tx rate
pigtail
μC based; SMB
SD Standard 1
RF connector
Numeric
value
Commercial temp.
C
range (0-70C)
Integrated Triplexer, Curb
BPON, Class B, SC
C
C
2
622Mbps
F
4x
Application
receptacle
Customer
μC based; 3-pin
xy
2
specific
RF connector
Integrated Triplexer, Digital
GPON, 25dB budget,
D
G
3 1244Mbps E
8x
Only
SC/APC pigtail
GPON, 28dB Budget,
Integrated Triplexer, Video
V
H
SC/APC Pigtail
4 2488Mbps S
16x
Only
(FP Laser)
GPON, 28dB Budget,
D
SC/APC Pigtail
5
(DFB Laser)
4800Mbps
μC based; SMB;
3
BPON gain
μC based; SMB;
5
HIGH gain
μC based; 3RF;
6
HIGH gain
μC based; SMB;
7
Next gen.
μC based; 3RF;
8
Next gen.
Table 12 - Device Handling/ESD Protection
The devices are static sensitive and may easily be damaged if care is not taken during handling. The following handling practices are
recommended.
1 Devices should be handled on benches with conductive and grounding surfaces.
2 All personnel, test equipment and tools shall be grounded.
3 Do not handle the devices by their leads.
4 Store devices in protective foam or carriers.
5 Avoid the use of non-conductive plastics, rubber, or silk in the area where the devices are handled
6 All modules shall be packaged in materials that are anti-static to protect against adverse electrical environments.
Avoid applications of any voltage higher than maximum rated voltages to this part. For proper operation, any VIN or VOUT should be
7 constrained to the range GND ≤ (VIN or VOUT) ≤ VCC. Unused inputs must always be tied to an appropriate logic voltage (e.g.
either GND or VCC). Unused outputs must be left open.
DS2302-Rev A.1